Confetti Napkin Rings!

Why make Confetti Napkin Rings in easy steps. Because who doesn't love confetti? DIY Tutorial in the link - The CraftablesHave you ever met a person who doesn’t like confetti? I can’t think of a single person. Sure, it’s messy. But, it represents so much fun and colour and happiness. More than makes up for the 5 minutes, you need to spend clearing it up. That’s the spirit with which we made these Confetti Napkin Rings. They were for a small dinner, where we wanted to add some festivity & brightness to the table. And, this was our subtle way of doing that. Here’s how to make them.

Why make Confetti Napkin Rings in easy steps. Because who doesn't love confetti? DIY Tutorial in the link - The Craftables

Budget: Low

Time: 5 minutes prep time. 5 minutes execution & 30 minutes to dry

Materials:

  • Thin plastic or thick paper
  • Wire Ribbon / Thin wire
  • Mod Podge
  • Double Sided Tape/Glue
  • Confetti (we cut up scrap paper to make it in 5 minutes)
  • Napkins

Why make Confetti Napkin Rings in easy steps. Because who doesn't love confetti? DIY Tutorial in the link - The Craftables

Steps to make confetti napkin rings:

  1. Cut two strips of plastic – 1 inch wide and 7 inches long. Flatten them out, and stick double sided tape in the centre of one of them.
  2. Paste wire ribbon in the centre of this tape & paste the second strip of plastic over it.  Cut off the excess wire and plastic, you only need about 6 inches to make the ring.
  3. Lightly coat the top layer with mod podge or glue and sprinkle confetti over it. Make sure to leave a little bit of the edge from one side. And that none of the edges are sticking out too much.
  4. Cover the confetti with a single thin layer of mode podge & let it dry.
  5. Once it has dried out completely, put glue or double sided tape on one side of the strip & paste the other side on it.

Why make Confetti Napkin Rings in easy steps. Because who doesn't love confetti? DIY Tutorial in the link - The Craftables

Slip it onto your napkins. We used a dark green, that blended well with all the colours. 

Things to remember:

  • Make sure to spread the plastic out completely when pasting the wire. Avoid air bubble as much as possible.
  • Don’t use too much mode lodge or it would clear out completely. We used the glossy finish one, to give the ring some shine.
  • Make sure the wire is covered completely with confetti.
  • You can add another layer of confetti, if it’s too thin or if the colours aren’t blending.

Why make Confetti Napkin Rings in easy steps. Because who doesn't love confetti? DIY Tutorial in the link - The Craftables

Any thoughts? Let us know! Have a great day ahead and Happy Crafting!

Category: Decor

Leave a Reply

Your email address will not be published. Required fields are marked *

2 thoughts on “Confetti Napkin Rings!